How can I do 123.HP.com/setup for HP Printer?

Removing the printer and all packaging materials from the box, connecting the power cable, installing the ink cartridges, loading paper into the input tray, downloading and installing the printer software, and finally aligning the ink cartridges are the steps needed for 123.hp.com/setup for the first time.

Steps to Set Up HP Printer With 123.HP/Setup

 There are steps from which you can easily set up your HP printer easily as follows:

Step 1:  Take the printer out of the box.

By country or location, the contents may change. A list of the things shipped in the box can be seen on the packaging. To start the process of 123. hp/setup, take the printer out of the box and off the plastic wrap.

 

1. Take the printer out of the packaging.

2. Take off the printer's plastic covering.

3. Reuse or recycle the packaging.

Step 2: Set Your Preferences to plug in the power cord.

1.       Turn on the printer after plugging it into a wall outlet.

2.       Attach the printer's power cord to the back, and then plug the other end of the cord into an outlet.

3.      Switch the printer on.

Step 3: Install the ink cartridges in step three.

Install your printer's HP ink cartridges that were packaged with it.

1. Open the access door for the ink cartridges.

The printer's carriage is moved to the printer's center.

2. Remain silent and patient until the carriage is free to go again.

3. Take the fresh ink cartridge out of the packaging. Be careful to only touch the ink cartridge's black plastic.

4. Take off the ink cartridge's plastic tape. 

5. Insert the ink cartridge into its slot while holding it by its sides with the contacts facing the printer, and then gently push it in until it snaps into place.

6. Carry out the same procedures for the second ink cartridge.

7. Lock the access door for the ink cartridges.

 

The initialization process for the printer begins. The printer will likely produce noises while performing this task 

Step 4: Place blank paper in the input tray 

Place A4 or US letter-size blank paper in the input tray.

1. Raise the input tray and the extender for the input tray.

2. Pull back and hold the input tray shield before moving the paper width guide all the way to the left and releasing it.

3. Fill the input tray with up to 60 sheets of plain white paper, then move the stack of paper down until it stops.

4. Slide the paper width guide to the right until it reaches the edge of the paper, then release the input tray shield. Pull the input tray shield back while holding it in place.

5. Lift the paper catch after removing the output tray and the output tray extender.

Step 5: Install the printer software

1.       You can now install the printing software after setting up the HP printer hardware.

2.       Wait until the printing software instructs you to do so before attempting to connect the printer to a computer.

3.       Visit the HP website at 123.hp.com/dj3700 to get the most recent version of the printing software. 

Summary 

These above steps can assist you in 123.hp.com/setup easily and quickly. We advise you to get in touch with customer service if you are again experiencing issues with your HP printer. Additionally, it's crucial to set up your printer as soon as you can because issues might arise with hardware as well as software.